Making a digital camera is a project that appears easy enough, but it’s one whose complexity increases depending on the level to which a designer is prepared to go. At the simplest a Raspberr…
It would be super cheap to make a laser difraction grid. You could map the lense deformation because you know the lines on the grid are straight. This would be solely for mapping the properties of the lens / mount and how to handle defamation profiles. Once you dial in the lens you probably wouldn’t need to run it again assuming it can id the lens when you mount it.
I would say you could use red green and blue lasers and look at convergence, But I’m not sure in any decent hardware that that would actually be off
You aim it at what? Who has that?
It would be super cheap to make a laser difraction grid. You could map the lense deformation because you know the lines on the grid are straight. This would be solely for mapping the properties of the lens / mount and how to handle defamation profiles. Once you dial in the lens you probably wouldn’t need to run it again assuming it can id the lens when you mount it.
I would say you could use red green and blue lasers and look at convergence, But I’m not sure in any decent hardware that that would actually be off
“It would be” so you haven’t done this but speak confidently about it being cheap and accessible?