I made the plunge about a year ago. Spectrum assigns me a prefix but routing was spotty at best. In the end after all the troubleshooting pointed to the problem being the ISP I gave up and stuck with what works, IPv4.
It’s honestly super simple to set up. Outside of your ISP config it’s almost all autoconfig. 100% of the complication (at least for me) comes from knowing ipv4 first for 20 years and then trying to incorrectly map those concepts to V6.
As soon as I “let go” it was fine.
There’s not a huge net benefit you’re right. I mostly wanted to learn and I hope to be at the front edge of disabling ipv4 in the near distant future.
An issue I had the last time I tried to set up IPv6 up was pihole didn’t work as well as I would have preferred. I assumed I just didn’t set up things correctly and it’s looking like that is the case based on the OP.
It kept resolving ad domains with their IPv6 address.
The benefit is being able to easily access devices from the internet. The same address works on the LAN and WAN. There’s no port forwarding, so multiple devices can have the same port open. You also don’t need to mess with a VPN if your IPv4 connection uses CGNAT.
Each year I seem to think “this will be the year I set up IPv6 in my homelab” - but then I never get around to it.
If I have to run both v4 and v6 concurrently, there isn’t much incentive/motivation for me to use v6 locally.
Maybe I’ll get around to it when there’s a net benefit for me for my use case, or when I’m forced to.
Am I just imagining it to be more complicated than it actually is?
My router runs pfsense and I have 6 VLANs each with its own subnet - Management, Trusted, IoT, Cameras, Guest, and Web Facing Servers.
Its a mind shift cause so use to NAT and ipv4. But it is not they hard. I’m glad I learned it, but the beginning was tuff.
I made the plunge about a year ago. Spectrum assigns me a prefix but routing was spotty at best. In the end after all the troubleshooting pointed to the problem being the ISP I gave up and stuck with what works, IPv4.
It’s honestly super simple to set up. Outside of your ISP config it’s almost all autoconfig. 100% of the complication (at least for me) comes from knowing ipv4 first for 20 years and then trying to incorrectly map those concepts to V6.
As soon as I “let go” it was fine.
There’s not a huge net benefit you’re right. I mostly wanted to learn and I hope to be at the front edge of disabling ipv4 in the near distant future.
An issue I had the last time I tried to set up IPv6 up was pihole didn’t work as well as I would have preferred. I assumed I just didn’t set up things correctly and it’s looking like that is the case based on the OP.
It kept resolving ad domains with their IPv6 address.
Who cares if it access them over ipv6. Their still blocked.
If ad domains can be resolved to their IPv6 addresses, it means that they are not blocked. Your device connects to the IPv6 address and serves the ad.
I can’t remember what the problem was but my window to rollback was closing so I reverted back to IPv4 only and pushed it to another day.
The benefit is being able to easily access devices from the internet. The same address works on the LAN and WAN. There’s no port forwarding, so multiple devices can have the same port open. You also don’t need to mess with a VPN if your IPv4 connection uses CGNAT.
Yeah dropping Nat is the biggest net benefit I agree but I think the avg person won’t really find that much value in it when Nat works ok
And the average person is going to be using it without knowing. And never complain or anything.
Yea, prolly already using it.
NAT works fine until you get stuck on CGNAT and can’t host anything on IPv4 without using a VPN.