![](/static/253f0d9/assets/icons/icon-96x96.png)
![](https://lemmy.world/pictrs/image/8286e071-7449-4413-a084-1eb5242e2cf4.png)
Exactly. I moved to Jellyfin because Emby introduced the life time support thing
Exactly. I moved to Jellyfin because Emby introduced the life time support thing
I’m not sure what the right model is to get money flowing in. It seems like they took the easy route. 100 dollars for a server licence is not really that small amount considering that most server users are families? I would have preferred massive fund raising campaigns … I’m a bit lazy and need lots of nagging to get my credit card out … But its right these guys get some income for their work. As long as code remains AGPL … I bet soon there will be a fork like happened with Emby. I ended up purchasing the server licence a a few month later moved to the forked version …🙂
DEC740
Very nice but looks expensive. Do you think I could upload the pfSense configuration to it? I dread the pain of having to configure the whole thing from scratch.
I dont’ have IDS/IPS installed on my pfsense box.
Any more specific recomendation of the machine you have running?
sudo ethtool enp2s0 | egrep ‘Speed|Duplex’
Assuming you mean running these in the command prompt of pfSense? Tried but says “not found”. Same for “ip link”
I probably didn’t realise how CPU intensive the work of 1Gbit connection must be …
Yes, checked and are all on the 1000M (1G) link
Any thoughts on a good little fanless device that I can use as a pfSense machine that has a resonable CPU. I would just swap the SSD from my curent device to the new one and it should all work nicely.
Ok, starting to think I need a new little device for my pfSense. I was thinking of going OpenSense and buying one of their devices to support the project.
Regarding my switch, the ports where my Rukus APs are connected are showing 1000M on the interface. But I think a step by step testing is what is needed as suggested above.
This is an intersting thread because I read through the lines the concerns that many have about losing parts of their homelab. Something I too am concerned about. While I have learnt to put my data securely on NAS with docker compose (I.e. docker image runs on VM while data i s stored on NAS and nas dataset is mounted via NFS on VM), in still not clear ho I save the config on the docker container. Basicalky, if I want to move that docker image to a new VM, how do I go about it?
This thread has reminded me that I have Ruckus APs that mesh. But support had been dropped because they are “old”. Presumably there is no open source solution that I can flsh these with, still allowing me the meshing?